Triumph DAYTONA 675 Service Manual page 294

2. If removed, loosely fit the spring and collar on the
stepper motor arm.
1. Collar
2. Spring
3. Locate the stepper motor to its bracket and tighten
the fixings to 3.5 Nm.
1. Idle speed control stepper motor
2. Bracket
3. Fixings
4. Direction of fitting
4. Fit the plastic washer to the lever then fit the metal
washer and nut.
cc
1. Idle speed control lever
2. Nut etc.
Service Manual - Daytona
1llMP
Fuel System/Engine Management
5. Mount the throttle body onto the engine.
6. Temporarily reconnect the battery, positive (red) lead
first.
7.
Attach the Triumph diagnostic tool to the dedicated
plug, refer to the Triumph Diagnostic Tool User
1
Guide.
8. Turn the ignition to the 'ON' position.
9. On the diagnostic software navigate to and select the
'ADJUST TUNE' option.
10. Select Idle Speed Control Stepper Motor Adjust then
click the Adjust button.
11. On pressing the adjust key, the diagnostic tool will
send a command that drives the throttle to the fully
closed position. The tool will also display the voltage
reading coming from the throttle position sensor
which should be between the target voltage range of
0.58V and 0.62V
12. Tighten the stepper arm nut on the idle speed
stepper motor until a clearance of 0.5 mm can be
measured between the idle speed control cam and
the throttle roller.
3
1. Idle speed control lever
2. Throttle roller
13. Check the voltage reading shown on the software. If
the reading is between the target voltage range,
then proceed to step 17. If the reading is not within
this range, adjustment must be made as described in
steps 14 to 16.
14. Slacken the screws on the throttle position sensor.
15. Gently turn the throttle position sensor until the
voltage reading shown on the software is between
the target voltage range.
16. Tighten the sensor retaining screws to 2 Nm and
recheck the voltage reading shown on the software.
Repeat the adjustment if the reading is outside the
specified range.
17. Click the OK button to progress to the next
adjustment.
675,
Street Triple and Street Triple
10.1 13
R