Triumph DAYTONA 675 Service Manual page 306

A
Warning
Incorrect alignment of the exhaust clamp may cause
interference with the rear suspension which may lead to
loss of motorcycle control and an accident.
16. Align the intermediate pipe clamp to the header pipe
as shown below and tighten to 15 Nm.
1. Intermediate pipe
2. Clamp
3. Header pipe
4. Alignment marks
17. Position and engage the right hand silencer to the
intermediate pipe.
18. Refit the spacer (if removed) to silencer bolt in the
rear subframe, and align the silencer mounting
bracket to the spacer. Refit the nut. Tighten the
fixings to 15 Nm.
2
cere
1. Silencer mounting bracket fixing
2. Nut
19. Repeat steps 17 and 18 above for the left hand
silencer.
Service Manual - Daytona 675, Street Triple and Street Triple
IuMP
Fuel System/Engine Management
20. Align the intermediate pipe joint clamps such that
the bolts are vertical as shown below, and tighten to
10 Nm.
1. Intermediate pipe joint clamps showing bolt alignment
2. Header pipes
3. Left hand silencer
4. Right hand silencer
21. Reconnect the battery, positive (red) lead first.
Ak
Caution
Do not install the exhaust system or run the engine
without the exhaust heatshields fitted. Components
protected by the exhaust heatshields may suffer severe
damage or a fire if the motorcycle is operated without
the heatshields being fitted.
22. Start the engine and check for exhaust gas leaks.
Rectify if necessary.
Refit the rear bodywork (see page 16-18).
23.
24. Refit the seat (see page 16- 17).
10.125
R