Triumph DAYTONA 675 Service Manual page 275

Fuel System/Engine Management
Connect the adapter hose to the fuel pump plate
5.
outlet as shown in the illustration below.
cdv
1. Adaptor hose 'B'
2. Fuel pump plate outlet
3. Extension cable T3880123
Connect the fuel hose to the adaptor hose as shown
6.
in the illustration below.
1. Motorcycle fuel hose (Daytona 675 shown)
2. Adaptor hose 'B'
3. Fuel pump connection
4. Wiring extension T3880123
5. Fuel pump connection
6. Fuel pump plate outlet
1 0.94
Service Manual - Daytona 675, Street Triple and Street Triple R
7. Connect the fuel pressure gauge to the adaptor hose
as shown below by pushing the gauge spigot in to
adapter until a click can be heard.
1
1.Adaptor hose
2. Fuel pressure gauge
Note:
• To release the fuel pressure gauge from the
adapter, slide the outer ferrule downwards.
This will allow the gauge to spring upwards
from the adapter.
8. Ensure the gauge is visible to the side of the
motorcycle.
9. Start the engine and observe the fuel pressure
reading on the gauge.
Note:
• The fuel pressure should be 3.0 bar
nominally.
10. When fuel pressure checking is complete, disconnect
the fuel pressure gauge adapter and wiring
extension.
11. Refit the fuel tank (see page 10-90).
12. Refit the rider's seat (see page 16-17).
I UMP