Headlightbulb Replacement; Positionlamp Bulb Replacement - Triumph DAYTONA 675 Service Manual

Note:
•
The horizontal beams of both headlights can
be adjusted individually. The same
procedure is used to adjust either headlight.
9. Switch the headlight dipped beam on.
10. Slacken the headlight bowl fixing.
11. Adjust the horizontal position of the headlight to give
the required beam setting.
12. Tighten the clamp bolt to 15 Nm.
13. Repeat for the second headlight.
14. Re-check the headlight beam settings.
15. Switch the headlights off when both beam settings
are satisfactorily set.
A
Warning
Adjust road speed to suit the visibility and weather
conditions in which the motorcycle is being
operated.
Ensure that the headlight beam is adjusted to
illu minate the road surface sufficiently far ahead
without dazzling oncoming traffic. An incorrectly
adjusted headlight may impair visibility causing an
accident.
Headlight Bulb Replacement
cbnp
1. Headlight bulb
2. Bulb clip
3. Position lamp
Each headlight bulb can be replaced as follows:
Service Manual - Daytona 675, Street Triple and Street Triple R
L UMP
The bulb becomes hot during use. Always allow
sufficient time for the bulb to cool before handling.
Avoid touching the glass part of the bulb. If the glass
is touched or gets dirty, clean with alcohol before re-
use.
Do not reconnect the battery until the assembly
process has been completed. Premature battery
reconnection could result in ignition of the battery
s ng
ga es causi
Tj
1. Disconnect the battery, negative (black) lead first.
2.
Release the clamp screw for the headlight bezel.
3.
Support the headlight and remove the bezel.
Ease the headlight from the headlight bowl.
4. Disconnect the multi-pin electrical connector
from the headlight bulb, then remove the rubber
cover.
5. Unhook the wire retaining clip from behind the
bulb.
6. Remove the bulb from the headlight unit.
7.
Installation is the reverse of the removal
procedure. Tighten the clamp screw to 4 Nm.
Note:
•
When reconnecting the battery, connect
the positive (red) lead first.
Position Lamp Bulb Replacement
Position lamp bulbs are fitted to both headlight units.
To replace a position light bulb, remove the headlight
unit from the headlight bowl to gain access for
position light bulb replacement.
Electrical
Warning
Warning
risk of injury.
1 7.25