Triumph DAYTONA 675 Service Manual page 438

Wheels/Tyres
Front Wheel Bearings
Removal
1. Remove the front wheel (see page 15-6).
A
Caution
Do not allow the wheel to rest on the brake discs, as this
may damage the discs. Support the wheel on wooden
blocks, equally spaced around the rim, such that the
brake discs are raised above the ground.
2. Place the wheel on wooden blocks to prevent
damage to the brake discs.
3. Remove and discard the seals and the bearing circlip.
©
Warning
Always wear eye, hand and face protection when using
a hammer and drift. Use of a hammer and drift can
cause bearings to fragment. Pieces of fragmented
bearing could cause eye and soft tissue injuries if
suitable protective apparel is not worn.
A
Caution
To prevent wheel damage and to aid bearing removal,
always apply force evenly on both sides of the bearing
to prevent it from 'tipping and becoming stuck.
Application of uneven force will lead to difficulty in
removing the bearing and to a damaged wheel.
4. Using a suitable pin punch, through the centre of the
wheel, drift out the wheel bearings. Collect the
centre sleeve.
Wheel Bearing Removal
15.10
Service Manual - Daytona 675, Street Triple and Street Triple R
Inspection
Warning
Only remove raised witness marks from within the
wheel. Removal of material below any raised areas will
reduce the level of interference between the wheel and
the bearings. Loss of interference could cause the
bearing to become loose in the wheel leading to loss of
motorcycle control a n d an a ccid e nt.
1. Examine the wheel for any raised witness marks
caused by the removal process. Remove any such
marks with fine emery paper or a gentle file.
Installation
Note:
•
Refer to the chart below for the correct tool
and tool face when inserting bearings.
Bearings are inserted by means of a draw -
bolt acting on the insertion tool. A support
tool is located on the opposite side of the
wheel to the insertion tool and as the bolt is
tightened, the bearing is drawn into the
wheel.
• Insert bearings with the marked or shielded
side facing outwards and always fit a new
bearing circlip and seals.
Bearing insertion
tool
Left bearing
T3880053
Small face
bearing
Right bearing T3880053
Small
face
bearing
Support tool
3880065 -
T0301
to
Large
face to
Wheel
3880065 -
T0301
to
Large face
to
wheel
Il1MP