Disposalof Used Engine Oil - Triumph DAYTONA 675 Service Manual

Lubrication
Unscrew and remove the oil filter using Triumph
6.
service tool 13880313.
1. Oil filter
2. Tool T3880313
7. Discard the oil filter.
8. Apply a smear of clean engine oil to the sealing ring
of the new oil filter.
Fit the oil filter and tighten to 10 Nm using Triumph
9.
service tool T3880313.
10. After the oil has completely drained out, fit a new
sealing washer to the drain plug. Fit and tighten the
plug to 25 Nm.
11. Fill the engine with new oil of the type and grade
listed previously and in the specification section.
Service Manual - Daytona 675, Street Triple and Street Triple R
8.8
12. Start the engine and allow to idle.
ACaution
Racing the engine before the oil reaches every part can
cause engine damage or seizure.
13. Ensure that the oil
extinguishes shortly after starting.
ACaution
If the engine oil pressure is too low, the low oil pressure
warning light will illuminate. If this light stays on when
the engine is running, stop the engine immediately and
investigate the cause. Running the engine with low oil
pressure will cause engine damage.
14. Stop the engine and check the oil level. Adjust if
necessary.
15. Daytona 675 only: Refit the lower fairings (see
page 16-22).
Disposal of Used Engine Oil
To protect the environment, do not pour oil on the
ground, down sewers or drains, or into water courses.
Dispose of used oil sensibly. If in doubt contact your local
authority.
pressure warning light
IL1MP