Triumph DAYTONA 675 Service Manual page 177

Engine Removal/Refit
Note:
• The frame is fitted with four frame adjuster
sleeves, located on the left hand side of the
frame, as shown below.
1. Front frame adjuster position
2. Centre frame adjuster position
3. Rear upper frame adjuster position
4. Rear lower frame adjuster position
21. Using tool 13880103, slacken the two rear frame
adjuster sleeves.
1.Tool T3880103
2. Rear upper frame adjuster
3. Rear lower frame adjuster
22. Release the nuts securing the left hand centre and
front engine mounting bolts and remove the bolts.
9.4
Service Manual - Daytona 675, Street Triple and Street Triple R
23. Using tool T3880103, slacken the centre and front
frame adjuster sleeves.
2
4
COLIC
1.Tool T3880103
2. Front frame adjuster
3. Centre frame adjuster
24. Remove the two remaining (right hand) engine
mounting bolts and lower the engine sufficiently to
allow the drive chain to be detached from the output
sprocket.
25. Remove the engine from the frame.
A
To prevent damage to components, lower the engine
very carefully.
Installation
1. Position the engine beneath the frame.
2. Raise the engine, looping the drive chain over the
output sprocket as it is raised.
,
Unless the following engine mounting bolt installation/
tightening sequence is precisely followed, severe frame
damage can occur.
Align the engine to the frame and carefully fit the
3.
right hand centre engine mounting bolt (located at
the rear of the cylinder head) ensuring the engine is
still adequately and securely supported.
4. Align the left hand centre engine mounting and
using tool T3880103, tighten the frame adjuster to
3 Nm. Carefully fit the bolt but do not fully tighten
at this stage.
C]
Caution
Caution
.
t uMP