Inspection - Triumph DAYTONA 675 Service Manual

Cooling
10. Remove the thermostat from the cylinder head
r
^^•1enam^ i

Inspection

1. Inspect the thermostat at room temperature. If the
valve is open, the thermostat must be replaced.
2. To check the valve opening temperature, suspend
the thermostat in a container of water and raise the
temperature of the water until the thermostat opens.
The thermostat should start to open at 71 °C +/- 5°C.
3. If the temperature at which thermostat opening
takes place is incorrect, replace the thermostat.
Installation
1. Locate the thermostat into the cylinder head. Ensure
the bleed valve is uppermost as shown below.
1. Thermostat
2. Bleed valve
11.12
Service Manual - Daytona 675, Street Triple and Street Triple R
2. Fit a new 0-ring to the thermostat elbow groove.
l
'. t
, .'C^<<o
TM
1. O-ring groove
3. Tighten the fi xings to 9 Nm.
4. Reconnect the top hose and tighten the clip.
5. Refit the throttle bodies (see page 10-108).
6.
Refit the airbox (see page 10-96).
7. Refi t the fuel tank (see page 10-90).
8. Reconnect the batte ry positive (red) lead first.
9.
Refit the rider's seat (see page 16-17).
10. Refill the cooling system (see page 11-7 for Daytona
675 or page 11-9 for Street Triple and
Street Triple R).
l" C
ILiMP