Rearbrake Disc; Wear - Triumph DAYTONA 675 Service Manual

5. Fill the master cylinder with new, DOT 4 brake fluid
from a sealed container.
6. Bleed the rear brake (see page 14-35).
7. Check for correct brake operation. Rectify as
necessary.
A
Warning
It is dangerous to operate the motorcycle with defective
brakes; you must have your authorised Triumph dealer
take remedial action before you ride the motorcycle
again. Failure to take remedial action may result in
reduced braking efficiency leading to loss of motorcycle
control and an accident.
Service Manual - Daytona 675, Street Triple and Street Triple R
I UMP
Rear Brake Disc

Wear

A
Warning
Before starting work, ensure the motorcycle is stabilised
and adequately supported. This will help prevent it from
falling and causing injury to the operator or damage to
the motorcycle.
1. Replace any brake disc worn beyond the service limit
or that exceeds the disc run-out limit.
Rear Disc Thickness
Standard:
Service Limit:
Disc Run-out
Service Limit:
Measure disc run-out using an accurate dial gauge
mounted on a surface plate.
1. Disc
2. Dial gauge
Note:
•
Details of rear brake disc removal and
installation can be found in the wheel
section.
Brakes
j
5.0 mm
4.5 mm
0.30 mm
2
1 4.41