Removal - Triumph DAYTONA 675 Service Manual

Fuel Sy stem/Engine Management
6. Set the 'opening' cable adjuster at the throttle body
end to give 2-3 mm of play at the throttle grip.
Tighten the locknut.
1. 'Opening Cable Adjuster (Throttle End)
2. 'Closing' Cable Adjuster (Throttle End)
3. Closing cable — free play measurement point
7. With the throttle fully closed, ensure that there is
2-3 mm of free play in the 'closing' cable. Adjust if
necessary ensuring that the locknut is secure
afterwards.
Warning
Operation of the motorcycle with incorrectly adjusted,
incorrectly routed or damaged throttle cables could
interfere with the operation of the brakes, clutch or the
throttle itself. Any of these conditions could result in loss
of motorcycle control and an accident.
Warning
Move the handlebars to left and right full lock while
checking that cables and harnesses do not bind. Cables
or harness that bind will restrict the steering and may
ca u se loss of motorcycle control and an accident.
©
Warning
Ensure that the adjuster locknuts are tightened. A loose
throttle cable adjuster could cause the throttle to stick
leading to loss of motorcycle control and an accident.
Refit the airbox (see page 10-96).
8.
9. Refit the fuel tank (see page 10-90).
10. Reconnect the battery, positive (red) lead first.
11. Refit the rider's seat (see page 16-17).
1 0.104
Service Manual - Daytona 675, Street Triple and Street Triple R

Removal

Note:
•
Before beginning to remove the throttle
cables, note the exact routing and location
of both cables to help ensure that they are
returned to the same locations and routing
on assembly.
1.
Remove the rider's seat (see page 16- 17).
2. Disconnect the battery, negative (black) lead first.
(see page 17-14).
3. Remove the fuel tank (see page 10-89).
4. Remove the airbox (see page 10-95).
5. Detach the throttle bodies (see page 10- 106).
6. Slacken the adjuster locknuts at the throttle body end
of the cables such that they will allow the outer
cables to be detached from the cable bracket.
II
7.
Detach the inner cable nipples from the throttle cam.
1.Throttle cam
2. Opening cable
3. Closing cable
4. Opening cable nipple
5. Closing cable nipple
3
(LIMP