Triumph DAYTONA 675 Service Manual page 173

Installation
Fit a new O-ring to the heat exchanger, and a new
1.
sealing washer to the centre bolt.
2
1. Centre bolt
2. Sealing washer
3. Heat exchanger
4. 0-ring
Note:
To ensure correct positioning, ensure that
•
the tab on the heat exchanger locates in the
boss provided in the crankcase.
ACaution
Do not rely on the tab to hold the heat exchanger in
position while tightening the centre bolt. The tab will
bend and will not prevent the heat exchanger from
turning. Instead, firmly hold the heat exchanger in
position by hand.
1
1. Heat exchanger tab
2. Crankcase boss
Fit the heat exchanger to the crankcase and tighten
2.
the centre bolt to 59 Nm.
Service Manual - Daytona 675, Street Triple and Street Triple R
I UMP
3. Fit the coolant hoses to the heat exchanger and
tighten the coolant hose clips.
4
1. Heat exchanger
2. Centre bolt
3. Coolant hoses
Refill the cooling system (see page 11-7 for Daytona
4.
675 and page 11-9 for Street Triple and
Street Triple R).
Refill the engine with oil (see page 8-7).
5.
6. Daytona 675 only:
page 16-22).
7. Reconnect the battery, positive (red) lead first.
tart t e engine an c ec or of I I eak s. O n 1
S
h
U.
check has been made, stop the engine and allow to
stand for 3 minutes.
9. Adjust the engine oil level (see page 8-6).
10. Refit the rider's seat (see page 16-17).
Lubrication
Refit the lower fairings (see
d h kf ce a eak
t
8.19