Throttlebody Balancing - Triumph DAYTONA 675 Service Manual

Throttle Body Balancing
Note:
•
The throttles cannot be balanced using
equipment to measure vacuum in each
throttle. Instead, the Triumph diagnostic
software must be used.
1. Remove the rider's seat (see page 16- 17).
2. Remove the fuel tank (see page 10-89) and place on
a suitable support, close to the motorcycle.
3. Remove the airbox (see page 10-95).
©
Warning
If the engine has recently been running, the
components beneath the fuel tank may be hot to the
touch.
4. Turn the ignition to the 'OFF' position.
5. Using the extension cable T3880123, carefully
connect the fuel pump connection on the main
harness to the fuel tank. Connect the other end of
the harness extension to the motorcycle main
harness.
6. Select the fuel pressure gauge adapter marked 'B'
from service tool T3880001.
A Warning
Always us the correct fuel pressure gauge adapter
(adapter 'B' for Daytona 675, Street Triple and
Street Triple R). Use of an incorrect adapter will result
in a fuel leak. A fuel leak can result in a fire causing
damage to property and injury to persons.
Service Manual - Daytona 675, Street Triple and Street Triple R
ll.i MP
Fuel System/Engine Management
7.
Connect the adapter hose to the fuel pump plate
outlet as shown in the illustration below.
1. Adaptor hose 'B'
2. Fuel pump plate outlet
3. Tool T3880123
8.
Connect the fuel hose to the adaptor hose as shown
in the illustration below.
1. Motorcycle fuel hose
2. Adaptor hose 'B'
3. Fuel pump connection
4. Wiring extension T3880123
5. Fuel pump connection
6. Fuel pump plate outlet
9. Attach exhaust extraction hoses to the silencer.
10. Attach the Triumph diagnostic tool to the dedicated
plug, refer to the Triumph Diagnostic Tool User
Guide. Start the engine, and allow to idle.
11. On the diagnostic software navigate to 'ADJUST
TUNE'.
12. Select 'BALANCE THROTTLES'.
13. Click the Adjust button.
1 0.109