Front Suspension Installation; Fork Oil Change - Triumph DAYTONA 675 Service Manual

Front Suspension
Installation
1. Position the forks within the yokes so that the lip of
the outer tube, not the top cap, is 4 mm above the
upper surface of the top yoke.
Note:
• Daytona 675 shown, Street Triple similar.
1. Outer tube
2. Top cap
3. Top yoke
Tighten the bottom yoke clamp bolts to 20 Nm.
2.
3. Tighten the top yoke clamp bolts to 26 Nm.
4. Daytona 675 only: Tighten the handlebar clamp
bolts to 26 Nm.
Note:
• If the forks have been dismantled, tighten
the fork top caps to 25 Nm.
Refit the front mudguard. Tighten the fixings to
5.
6 Nm.
6. Install the front wheel (see page 15-7).
Refit the front brake calipers;
7.
• see page 14-23 for Daytona 675 up to
VIN 381274 and Street Tiple;
• see page 14-25 for Daytona 675 from
VIN 381275;
• see page 14-28 for Street Triple.
8. Lower the motorcycle to the ground and park it on
the side stand.
13.8
Service Manual - Daytona 675, Street Triple and Street Triple R

Fork Oil Change

Draining
Before starting work, ensure the motorcycle is stabilised
and adequately supported. This will help prevent it from
falling and causing injury to the operator or damage to
the motorcycle.
1. Remove the fork (see page 13-6).
2. Remove the top cap assembly (see page 13-10).
3. Remove the fork spring (see page 13- 70).
i mm
4.
Holding the inner and outer tubes together, invert
the fork and pour out the fork oil into a suitable
container. Pump the damper rod to remove all the
oil.
Oil Refilling
The oil level is measured from the upper surface of the
fork outer tube, with the fork fully compressed and the
spring removed.
For the measurement, refer
to the table below.
thy
Fork Oil Level (fully compressed)
Model
Daytona 675 up to VIN 381274
Daytona 675 from VIN 381275
Street Triple
Street Triple R
1. Fill the fork with the grade of oil specified in the fork
oil table, to a level above that which will finally be
required.
2. Pump the fork assembly and damper several times
to expel any trapped air then fully compress the fork
and support it in an upright position. Leave the fork
for a few minutes to allow the oil to stabilise.
A,
Warning
Oil Level
72 mm
89 mm
107 mm
93 mm
IIIMP