Triumph DAYTONA 675 Service Manual page 440

Wheels/Tyres
Inspection
A
Warning
Only remove raised witness marks from within the
wheel. Removal of material below any raised areas will
reduce the level of interference between the wheel and
the bearings. Loss of interference could cause the
bearing to become loose in the wheel leading to loss of
motorcycle control and an accident.
1. Examine the wheel for any raised witness marks
caused by the removal process. Remove any such
marks with fine emery paper or a gentle file.
Installation
Note:
Refer to the chart below for the correct tool
•
and tool face when inserting bearings.
Bearings are inserted by means of a draw -
bolt acting on the insertion tool. A support
tool is located on the opposite side of the
wheel to the insertion tool and as the bolt is
tightened, the bearing is drawn into the
wheel.
• Insert bearings with the marked or shielded
side facing outwards and always fit a new
bearing circlip and seals.
Bearing insertion
tool
Left bearing 3880070
T0301
Small face
bearing
Right bearing 3880070
T0301
Small face
bearing
15.12
Service Manual - Daytona 675, Street Triple and Street Triple R
1.
1. Tool T3880070
2.
3.
4.
Support tool
- 3880065 -
T0301
to
to Large face
Wheel
3880065 -
-
T0301
to Large face to
wheel
Fit the wheel bearings and centre sleeve using the
method described on the previous page.
/ // / I/ /I
COxh 11\
Fit a new circlip.
Lubricate and fit new seals to the rear wheel.
Lubricate the seal's knife-edge with grease to NLGI 2
specification (we recommend Mobil H P222),
Fit the rear wheel (see page 15-8).
L UMP