Headlightbulb Replacement; Positionlamp Bulb Replacement - Triumph DAYTONA 675 Service Manual

A
Warning
Adjust road speed to suit the visibility and weather
conditions in which the motorcycle is being operated.
Ensure that the beam is adjusted to illuminate the road
surface sufficiently far ahead without dazzling oncoming
traffic. An incorrectly adjusted headlight may impair
visibility causing an accident.
Headlight Bulb Replacement
1. Headlight unit
2. Bulb retainer
Each headlight bulb can be replaced as follows:
The bulb becomes hot during use. Always allow
sufficient time for the bulb to cool before handling.
Avoid touching the glass part of the bulb. If the glass is
touched or gets dirty, clean with alcohol before re-use.
A
Warning
Do not reconnect the battery until the assembly process
has been completed. Premature battery reconnection
could result in ignition of the battery gases causing risk
of injury.
1. Remove the rider's seat (see page 16-17).
2. Disconnect the battery, negative (black) lead first.
3. Remove the fairing infill panel (see page 16-20).
4. Remove the four screws and remove the bulb cover
from the bulb to be replaced.
5.
Disconnect the multi-plug from the bulb retainer.
Service Manual - Daytona 675, Street Triple and Street Triple R
LUMP
6. Detach the bulb retainer from the headlight
assembly by rotating it anti-clockwise.
7. Remove the bulb from the bulb retainer.
Installation
1.
Installation is the reverse of removal, noting the
following:
Note:
•
When reconnecting the battery, connect the
positive (red) lead first.
Position Lamp Bulb Replacement
The position lamps are fitted to the left and right of
each headlight. To replace a bulb, remove the two
screws and remove the bulb cover, detach the rubber
retainer from the headlight and pull out the bulb.
Installation is the reverse of the removal procedure.
1. Bulb holder
2. Position lamp bulb
Electrical
- 2
1
//
17.23