Triumph DAYTONA 675 Service Manual page 311

Fuel System/E ngine Management
2. Fit the cable nipples into the exhaust valve pulley
wheel.
1. Opening cable adjuster/locknuts
2. Closing cable adjuster/locknuts
3. Opening cable nipple
4. Closing cable nipple
5. Exhaust valve pulley wheel
Note:
• Where the outer cables locate into the
actuator, the cable outer sleeve is coloured
black on the upper, opening cable and silver
on the lower, closing cable.
3. Fit the inner portion of the cables to the actuator
pulley wheel, ensuring the pulley wheel is installed
with the fixing boss facing outwards, and the
opening (black) cable uppermost.
1
cdps
1.Actuator pulley wheel (fixing boss facing outwards)
2. Opening cable
3. Closing cable
4. Fixing boss
5. Black coating on cable outer
1 0.130
Service Manual - Daytona 675, Street Triple and Street Triple R
4.
2
3
Insert the outer portion of the cables into the
actuator.
5. Slide the actuator pulley onto the actuator shaft.
6. Install a new actuator pulley wheel fixing and tighten
to 5 Nm.
1. Actuator pulley wheel
2. Fixing
7. Adjust the exhaust valve cables (see page 10-131).
8. Refit the right hand lower fairing (see page 16-20).
9. Reconnect the battery, red (positive) lead first.
10. Refit the rider's seat (see page 16-17).
ILlMP