Selectorshaft, Selector Forks And Drum; Removal - Triumph DAYTONA 675 Service Manual

Selector Shaft, Selector Forks and
Drum

Removal

1. Remove the engine from the frame (see page 9-3).
2.
Separate the two halves of the crankcase (see page
5-4).
3. Remove the output shaft from the crankcase (see
page 7-12).
4. Release the two fixings and remove the baffle plate
from the crankcase breather. Discard the fixings.
1. Crankcase breather baffle plate
2. Fixings
5. If not already removed, note the position and
orientation of the gear pedal crank in relation to the
shaft, then remove the crank.
6. Remove the E-clip and washer from the gear pedal
end of the gear change shaft.
kalj,t
1. Gear change shaft
2. E-clip
3. Washer
Service Manual - Daytona 675, Street Triple and Street Triple R
I UMP
7.
1. Gear change shaft
Note:
8.
9.
1
1. Detent arm
2. Fixing
3. Spring
4. Detent wheel
a
Withdraw the gear change shaft from the clutch end
of the crankcase.
•
The detent arm is held in position under
spring pressure. Prior to removal, note the
orientation of the detent arm, fixing and
spring, relative to the selector drum detent
wheel. The same orientation must be
retained on assembly.
Remove and discard the fixing securing the detent
arm.
Withdraw the detent arm complete with its flanged
sleeve, spring and washer.
Transmission
1
7•7