Triumph DAYTONA 675 Service Manual page 302

Triumph daytona 675, street triple and street triple r
Hide thumbs Also See for DAYTONA 675:
Table of Contents

Advertisement

16. Align the clamp to the silencer to exhaust pipe joint
and tighten to 15 Nm. Ensure the clamp is aligned
as shown below.
1. Exhaust clamp position
2. Exhaust cut-out
3. Exhaust clamp alignment feature
on
L UMP
Service Manual - Daytona 675, Street Triple and Street Triple R
Fuel System/Engine Management
17.
Reconnect the battery, positive (red) lead first.
A
Caution
Do not install the exhaust system or run the engine
without the exhaust heatshields fitted. Components
protected by the exhaust heatshields may suffer severe
damage or a fire if the motorcycle is operated without
the heatshields being fitted.
18.
Start the engine and check for exhaust gas leaks.
Rectify if necessary.
Refit the lower fairings (see page 16-20).
19.
20.
Reconnect the direction indicator and licence plate
la mp electrical connector.
21.
Refit the rear bodywork (see page 16-18).
Refit the seats (see page 16-17).
22.
1 0.121

Advertisement

Table of Contents
loading

This manual is also suitable for:

Street tripleStreet triple r

Table of Contents