Headlights - Daytona 675 - Triumph DAYTONA 675 Service Manual

Electrical
Installation
1. Position the instrument pack to the bracket.
Insert the bayonet fixings into the grommets.
2.
Refit the fixing and tighten to 3 Nm.
3.
Connect the instruments to the harness.
4.
1. Screw
2. Washer
3. Bayonet fixings
4. Electrical connector
5. Install the cover and gasket to the rear of the
instruments, ensuring the bayonet fixings are fully
inserted in the grommets on the instrument bracket.
6. Reconnect the battery, positive (red) lead first.
Refit the rider's seat (see page
7.
1 7.22
Service Manual - Daytona 675, Street Triple and Street Triple R

Headlights - Daytona 675

Headlight Adjustment
Note:
n
1. Horizontal adjustment screw (left hand)
2. Vertical adjustment screw (left hand)
3. Horizontal adjustment screw (right hand)
4. Vertical adjustment screw (right hand)
5. Pivot screws (DO NOT adjust these screws)
1.
16-17).
Do not adjust the pivot screws as this could cause the
headlight reflector to become detached from the pivot
screw, leading to irreparable damage to the headlight.
2.
3.
4.
5.
• Each headlight can be adjusted by means of
vertical and horizontal adjustment screws
located on the rear of each headlight.
5
2
Switch the headlight dipped beam on.
ACaution
Turn the vertical adjustment screws on each
headlight clockwise to raise the beam or anti-
clockwise to lower the beam.
On the right hand headlight turn the horizontal
adjustment screw clockwise to move the beam to the
left or anti-clockwise to move the beam to the right.
On the left hand headlight turn the horizontal
adjustment screw clockwise to move the beam to the
right or anti-clockwise to move the beam to the left.
Switch the headlights off when both beam settings
are satisfactorily set.
3
4
I UMP