Triumph DAYTONA 675 Service Manual page 463

Frame and Bodywork
Installation
1. Refit the lower fairing infill panel to either fairing half.
2.
Position the fairing to the rear of the cockpit.
3. Reconnect the direction indicator connectors.
4. Align the fairing stud to the frame grommet and
refit.
5. Align the fairing stud to the fuse box grommet and
refit.
1. Fuse Box grommet/stud
6. Refit the lower fairing infill panel to the opposite
fairing half.
7.
Refit the fairing to cockpit lower fixing, and tighten to
3 Nm.
8. Refit the fairing to the fairing brackets, tighten the
fixings to 4 Nm.
9. From VIN 381275 only: If fitting the right hand
fairing, fit the indicator fixing and tighten to 3 Nm.
Ensure the fixing secures the alternator rectifier/
regulator to the fairing.
10. Refit the radiator infill panel fixings.
11. Refit the lower fairing fixings.
12. Refit the cockpit infill panels (see page 16-20).
13. Reconnect the battery, positive (red) lead first.
14. Refit the rider's seat (see page 16-17).
1 6.22
Service Manual - Daytona 675, Street Triple and Street Triple R
Windscreen - Daytona 675 up to
VIN 381274
Removal
Note:
•
It is not necessary to remove the mirrors to
remove the windscreen.
EM
1. Windscreen
2. Fixings
1. Release the eight windscreen fixings.
2. Slide the windscreen upwards and to the rear.
Installation
Installation is the reverse of removal noting the following.
Note:
•
Tighten the fixings to 0.5 Nm.
I UMP