Installation - Triumph DAYTONA 675 Service Manual

Fuel System/Engine M anagement
Note:
On Street Triple and Street Triple R models,
•
access to the fuel hoses connector is
restricted. An assistant may be required to
support the fuel tank whilst disconnecting
the fuel hose on these models.
• Before disconnection, note the position of
the two breather hoses so that they can be
returned to the same locations when
refitting the tank.
8. Disconnect the two breather hoses.
4
cdv
1. Fuel hose
2. Fuel pump electrical connection
3. Low fuel level sensor connection
4. Breather hoses
Remove the fuel tank from the frame.
9.
1 0.90
Service Manual - Daytona 675, Street Triple and Street Triple R

Installation

1. Position the fuel tank to the frame.
2. Connect the two breather hoses as previously noted.
Note:
•
The fuel hose has different coloured
connectors on each end, to aid orientation.
The orange end must be fitted to the fuel
tank, the grey end must be fitted to the fuel
rail.
3 Reconnect the fuel feed hose by gently pushing
inwards until the hose ehgages with a click.
4 Slide the double check latch down (i.e. towards the
spigot) until the release buttons are covered. If the
latch will not slide into position, then the fuel hose is
not fully home on its spigot and must therefore be
refitted correctly.
5. Reconnect the fuel pump electrical connection.
6. Reconnect the low fuel level sensor.
4
cdv
1. Fuel hose
2. Fuel pump electrical connection
3. Low fuel level sensor connection
4. Breather hoses
7. Align the fuel tank to the mounting points. Refit the
rear spacer sleeve. Fit and tighten the three bolts to
9 Nm.
8. Reconnect the battery, positive (red) lead first.
9. Start the engine and check carefully for fuel leaks.
Rectify as necessary.
Refit the rider's seat (see page 16-17).
10.
L UMP