Interrupt Id Register (Iir N ) - Intel 386 User Manual

Intel386™ EX EMBEDDED MICROPROCESSOR USER'S MANUAL

11.3.9 Interrupt ID Register (IIR n )

Use the IIRn to determine whether an interrupt is pending and, if so, which status signal generated
the interrupt request.
Interrupt ID
IIR0, IIR1
(read only)
7
— —
Bit Bit
Number Mnemonic
7–3 —
2 IS2:1
0 IP#
11-28
— —
Reserved. These bits are undefined.
Interrupt Source:
If an interrupt is pending (bit 0 = 0), these bits specify which status signal
caused the pending interrupt.
IS2 IS1 Interrupt Source
0 0 modem status signal*
0 1 transmitter buffer empty signal
1 0 receive buffer full signal
1 1 receiver line status signal**
* When one of the modem input signals (CTS n #, DSR n #, RI n #, and
DCD n #) changes state, the modem status signal is activated.
** A framing error, overrun error, parity error, or break interrupt activates
the receiver line status signal.
Reading the modem status register clears the modem status signal.
Reading the IIR n register or writing to the transmit buffer register clears
the transmit buffer empty signal. Reading the receive buffer register
clears the receive buffer full signal. Reading the receive buffer register or
the serial line status register clears the LSR n error bits, which clears the
receiver line status signal.
Interrupt Pending:
This bit indicates whether an interrupt is pending.
0 = Interrupt is pending
1 = No interrupt is pending
Figure 11-18. Interrupt ID Register (IIR n )
IIR0
Expanded Addr: F4FAH
ISA Addr: 03FAH
Reset State: 01H
— IS2 IS1
Function
IIR1
F8FAH
02FAH
01H
0
IP#