Removing The Fbu Holder From The Air Duct; Concluding Steps - Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual

Expansion cards and backup units
9.6.6.3

Removing the FBU holder from the air duct

Figure 119: Removing the FBU holder from the air duct (A)
Ê Lift up the green locking handle on the FBU holder (1) while sliding the FBU
holder to the left as far as it will go (2).
I
After that, the hooks on the air duct will rest in the wide ends of the
keyhole slots on the holder.
Ê Lift the FBU holder from the air duct (3).
9.6.6.4

Concluding steps

"Reassembling" on page 63
Ê
"Connecting the server to the power source" on page 69
Ê
"Switching on the server" on page 71
Ê
Ê If applicable, "Updating RAID controller firmware" on page
"Enabling SVOM boot watchdog functionality" on page 89
Ê
230 Upgrade and Maintenance Manual
84.
RX300 S8