Debug Platform Led - Cisco Catalyst 3030 Command Reference Manual

Appendix B Cisco Catalyst Blade Switch 3030 Debug Commands

debug platform led

Use the debug platform led privileged EXEC command to enable debugging of light-emitting diode
(LED) actions. Use the no form of this command to disable debugging.
Syntax Description generic
signal
Though visible in the command-line help strings, the stack keyword is not supported.
Note
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(25)SEE
Usage Guidelines
The undebug platform led command is the same as the no debug platform led command.
Related Commands Command
show debugging
78-17262-01
debug platform led {generic | signal}
no debug platform led {generic | signal}
Display LED generic action debug messages.
Display LED signal bit map debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Cisco Catalyst Blade Switch 3030 Command Reference
debug platform led
B-35