Cisco Catalyst 3030 Command Reference Manual page 335

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
This is an example of output from the show etherchannel 1 summary command:
Switch> show etherchannel 1 summary
Flags:
Number of channel-groups in use: 1
Number of aggregators:
Group
------+-------------+-----------+----------------------------------------
1
This is an example of output from the show etherchannel 1 port-channel command:
Switch> show etherchannel 1 port-channel
Port-channel: Po1
------------
Age of the Port-channel
Logical slot/port
HotStandBy port = null
Port state
Protocol
Ports in the Port-channel:
Index
------+------+------+------------------+-----------
0
0
Time since last port bundled:
This is an example of output from show etherchannel protocol command:
Switch# show etherchannel protocol
Group: 1
----------
Protocol:
Group: 2
----------
Protocol:
Related Commands Command
channel-group
channel-protocol
interface port-channel
78-17262-01
D - down P - in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
R - Layer3 S - Layer2
u - unsuitable for bundling
U - in use f - failed to allocate aggregator
d - default port
Port-channel Protocol
Po1(SU) LACP
Port-channels in the group:
----------------------
(Primary Aggregator)
= 01d:20h:24m:50s
= 10/1
= Port-channel Ag-Inuse
= LACP
Load Port EC state
00 Gi0/1 Active
00 Gi0/2 Active
Channel-group listing:
-----------------------
LACP
PAgP
Description
Assigns an Ethernet port to an EtherChannel group.
Restricts the protocol used on a port to manage channeling.
Accesses or creates the port channel.
1
Ports
Gi0/1(P) Gi0/2(P)
Number of ports = 2
No of bits
0
0
01d:20h:24m:44s Gi0/2
Cisco Catalyst Blade Switch 3030 Command Reference
show etherchannel
2-307