Debug Platform Led - Cisco Catalyst 3560-X Command Reference Manual

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug platform led

Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Related Commands
OL-21522-02
Downloaded from www.Manualslib.com
Use the debug platform led privileged EXEC command to enable debugging of light-emitting diode
(LED) actions. Use the no form of this command to disable debugging.
debug platform led {generic | signal | stack}
no debug platform led {generic | signal | stack}
generic Display LED generic action debug messages.
signal Display LED signal bit map debug messages.
stack Display LED stack action debug messages.
This keyword is supported only on Catalyst 3750-X switches.
Debugging is disabled.
Privileged EXEC
Release
12.2(53)SE2
The undebug platform led command is the same as the no debug platform led command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Command
show debugging
manuals search engine
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Catalyst 3750-X and 3560-X Switch Command Reference
debug platform led
B-59