Cisco Catalyst 3030 Command Reference Manual page 455

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
Though visible in the command-line help strings, the cpu [threshold], cluster, hsrp, msdp, ospf, pim,
Note
fru-ctrl, insertion, and removal keywords are not supported. The snmp-server enable informs global
configuration command is not supported. To enable the sending of SNMP inform notifications, use the
snmp-server enable traps global configuration command combined with the snmp-server host
host-addr informs global configuration command.
Defaults The sending of SNMP traps is disabled.
Command Modes
Global configuration
Command History Release
12.2(25)SEE
Usage Guidelines Specify the host (NMS) that receives the traps by using the snmp-server host global configuration
command. If no trap types are specified, all trap types are sent.
When supported, use the snmp-server enable traps command to enable sending of traps or informs.
Informs are not supported in SNMPv1.
Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command
for each trap type.
Examples This example shows how to send VTP traps to the NMS:
Switch(config)# snmp-server enable traps vtp
You can verify your setting by entering the show vtp status or the show running-config privileged
EXEC command.
Related Commands Command
show running-config
snmp-server host
78-17262-01
Modification
This command was introduced.
Description
Displays the running configuration on the switch. For syntax information,
select Cisco IOS Configuration Fundamentals Command Reference,
Release 12.2 > File Management Commands > Configuration File
Management Commands.
Specifies the host that receives SNMP traps.
Cisco Catalyst Blade Switch 3030 Command Reference
snmp-server enable traps
2-427