Errdisable Detect Cause - Cisco Catalyst 3030 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands

errdisable detect cause

Use the errdisable detect cause global configuration command to enable error-disabled detection for a
specific cause or all causes. Use the no form of this command to disable the error-disabled detection
feature.
Syntax Description all
dhcp-rate-limit
dtp-flap
gbic-invalid
link-flap
loopback
pagp-flap
Command Default
Detection is enabled for all causes.
Command Modes Global configuration
Command History Release
12.2(25)SEE
78-17262-01
errdisable detect cause {all | dhcp-rate-limit | dtp-flap | gbic-invalid | link-flap | loopback |
pagp-flap}
no errdisable detect cause {all | dhcp-rate-limit | dtp-flap | gbic-invalid | link-flap | pagp-flap}
Enable error detection for all error-disabled causes.
Enable error detection for DHCP snooping.
Enable error detection for the Dynamic Trunking Protocol (DTP) flapping.
Enable error detection for an invalid Gigabit Interface Converter (GBIC) module.
This error refers to an invalid small form-factor pluggable (SFP) module.
Note
Enable error detection for link-state flapping.
Enable error detection for detected loopbacks.
Enable error detection for the Port Aggregation Protocol (PAgP) flap
error-disabled cause.
Modification
This command was introduced.
Cisco Catalyst Blade Switch 3030 Command Reference
errdisable detect cause
2-87