Cisco Catalyst 3030 Command Reference Manual page 148

ip igmp max-groups
Examples This example shows how to limit to 25 the number of IGMP groups that a port can join:
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# ip igmp max-groups 25
This example shows how to configure the switch to replace the existing group with the new group for
which the IGMP report was received when the maximum number of entries is in the forwarding table:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# ip igmp max-groups action replace
You can verify your setting by using the show running-config privileged EXEC command and by
specifying an interface.
Related Commands Command
show running-config interface
interface-id
Cisco Catalyst Blade Switch 3030 Command Reference
2-120
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
Description
Displays the running configuration on the switch interface, including
the maximum number of IGMP groups that an interface can join and
the throttling action. For syntax information, select Cisco IOS
Configuration Fundamentals Command Reference, Release 12.2 >
File Management Commands > Configuration File Management
Commands.
78-17262-01