Cisco Catalyst 3030 Command Reference Manual page 671

Appendix B Cisco Catalyst Blade Switch 3030 Debug Commands
search
write {forw-ram | reg |
tcam}
Note Though visible in the command-line help strings, the l3 ipv6 {acl {input | output} | local | qos |
secondary}, the l3 local, and the l3 secondary keywords are not supported.
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(25)SEE
Usage Guidelines The undebug platform tcam command is the same as the no debug platform tcam command.
Related Commands Command
show debugging
78-17262-01
Display supervisor-initiated TCAM-search results debug messages.
Display TCAM-write debug messages. The keywords have these
meanings:
forw-ram—Display forwarding-RAM write debug messages.
reg—Display TCAM-register write debug messages.
tcam—Display TCAM-write debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Cisco Catalyst Blade Switch 3030 Command Reference
debug platform tcam
B-53