Cisco Catalyst 3030 Command Reference Manual page 61

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
Examples This example shows how to create a policy map called policy1. When attached to the ingress direction,
it matches all the incoming traffic defined in class1, sets the IP Differentiated Services Code Point
(DSCP) to 10, and polices the traffic at an average rate of 1 Mbps and bursts at 20 KB. Traffic exceeding
the profile is marked down to a DSCP value gotten from the policed-DSCP map and then sent.
Switch(config)# policy-map policy1
Switch(config-pmap)# class class1
Switch(config-pmap-c)# set dscp 10
Switch(config-pmap-c)# police 1000000 20000 exceed-action policed-dscp-transmit
Switch(config-pmap-c)# exit
You can verify your settings by entering the show policy-map privileged EXEC command.
Related Commands Command
class-map
police
policy-map
set
show policy-map
trust
78-17262-01
Description
Creates a class map to be used for matching packets to the class whose name
you specify.
Defines a policer for classified traffic.
Creates or modifies a policy map that can be attached to multiple ports to
specify a service policy.
Classifies IP traffic by setting a DSCP or IP-precedence value in the packet.
Displays quality of service (QoS) policy maps.
Defines a trust state for the traffic classified through the class policy-map
configuration command or the class-map global configuration command.
Cisco Catalyst Blade Switch 3030 Command Reference
class
2-33