Debug Platform Led - Cisco Catalyst 3120 Command Reference Manual

debug platform led

debug platform led
Use the debug platform led privileged EXEC command to enable debugging of light-emitting diode
(LED) actions. Use the no form of this command to disable debugging.
Syntax Description
generic
signal
stack
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(40)EX
Usage Guidelines The undebug platform led command is the same as the no debug platform led command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Cisco Catalyst Blade Switch 3120 for HP Command Reference
B-44
debug platform led {generic | signal | stack}
no debug platform led {generic | signal | stack}
Display LED generic action debug messages.
Display LED signal bit map debug messages.
Display LED stack action debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
OL-12248-01