Switchport Block - Cisco Catalyst 3030 Command Reference Manual

switchport block

switchport block
Use the switchport block interface configuration command to prevent unknown multicast or unicast
packets from being forwarded. Use the no form of this command to allow forwarding unknown multicast
or unicast packets.
Syntax Description multicast
unicast
Defaults
Unknown multicast and unicast traffic is not blocked.
Command Modes Interface configuration
Command History Release
12.2(25)SEE
Usage Guidelines By default, all traffic with unknown MAC addresses is sent to all ports. You can block unknown multicast
or unicast traffic on protected or nonprotected ports. If unknown multicast or unicast traffic is not
blocked on a protected port, there could be security issues.
Blocking unknown multicast or unicast traffic is not automatically enabled on protected ports; you must
explicitly configure it.
For more information about blocking packets, see the software configuration guide for this release.
Examples This example shows how to block unknown multicast traffic on an interface:
Switch(config-if)# switchport block multicast
You can verify your setting by entering the show interfaces interface-id switchport privileged EXEC
command.
Related Commands Command
show interfaces
Cisco Catalyst Blade Switch 3030 Command Reference
2-496
switchport block {multicast | unicast}
no switchport block {multicast | unicast}
Specify that unknown multicast traffic should be blocked.
Specify that unknown unicast traffic should be blocked.
Modification
This command was introduced.
switchport
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
Description
Displays the administrative and operational status of a switching port,
including port blocking and port protection settings.
78-17262-01