Cisco Catalyst 3030 Command Reference Manual page 440

show vlan
Table 2-27
Field
RingNo
BrdgNo
Stp
BrdgMode
Trans1
Trans2
Remote SPAN VLANs
This is an example of output from the show vlan summary command:
Switch> show vlan summary
Number of existing VLANs
Number of existing VTP VLANs
Number of existing extended VLANs : 0
This is an example of output from the show vlan id command.
Switch# show vlan id 1
VLAN Name
---- -------------------------------- --------- -------------------------------
1
VLAN Type
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
1
Remote SPAN VLAN
----------------
Disabled
Primary Secondary Type
------- --------- ----------------- ------------------------------------------
Cisco Catalyst Blade Switch 3030 Command Reference
2-412
show vlan Command Output Fields (continued)
Description
Ring number for the VLAN, if applicable.
Bridge number for the VLAN, if applicable.
Spanning Tree Protocol type used on the VLAN.
Bridging mode for this VLAN—possible values are source-route bridging
(SRB) and source-route transparent (SRT); the default is SRB.
Translation bridge 1.
Translation bridge 2.
Identifies any RSPAN VLANs that have been configured.
default
SAID MTU
enet 100001 1500
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
: 8
: 8
Status Ports
active Gi0/1, Gi0/2, Gi0/3, Gi0/4
Gi0/5, Gi0/6, Gi0/7, Gi0/8
Gi0/9, Gi0/10, Gi0/11, Gi0/12
Gi0/13, Gi0/14, Gi0/15, Gi0/16
Gi0/17, Gi0/18
Parent RingNo BridgeNo Stp
- - -
Ports
BrdgMode Trans1 Trans2
- - 0 0
78-17262-01