Ip Igmp Snooping - Cisco Catalyst 3030 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands

ip igmp snooping

Use the ip igmp snooping global configuration command to globally enable Internet Group
Management Protocol (IGMP) snooping on the switch or to enable it on a per-VLAN basis. Use the no
form of this command to return to the default setting.
Syntax Description vlan vlan-id
Defaults IGMP snooping is globally enabled on the switch.
IGMP snooping is enabled on VLAN interfaces.
Command Modes Global configuration
Command History Release
12.2(25)SEE
Usage Guidelines When IGMP snooping is enabled globally, it is enabled in all the existing VLAN interfaces. When IGMP
snooping is globally disabled, it is disabled on all the existing VLAN interfaces.
VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMP
snooping.
Examples This example shows how to globally enable IGMP snooping:
Switch(config)# ip igmp snooping
This example shows how to enable IGMP snooping on VLAN 1:
Switch(config)# ip igmp snooping vlan 1
You can verify your settings by entering the show ip igmp snooping privileged EXEC command.
78-17262-01
ip igmp snooping [vlan vlan-id]
no ip igmp snooping [vlan vlan-id]
(Optional) Enable IGMP snooping on the specified VLAN. The range is 1 to
1001 and 1006 to 4094.
Modification
This command was introduced.
Cisco Catalyst Blade Switch 3030 Command Reference
ip igmp snooping
2-123