Debug Platform Led - Cisco 3020 - Catalyst Blade Switch Command Reference Manual
Cisco catalyst blade switch 3020 for hp command reference, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Configuration manual (712 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Appendix B
Cisco Catalyst Blade Switch 3020 for HP Debug Commands
debug platform led
Use the debug platform led privileged EXEC command to enable debugging of light-emitting diode
(LED) actions. Use the no form of this command to disable debugging.
Syntax Description
generic
signal
Though visible in the command-line help strings, the stack keyword is not supported.
Note
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.2(25)SEF
Usage Guidelines
The undebug platform led command is the same as the no debug platform led command.
Related Commands
Command
show debugging
OL-8916-01
debug platform led {generic | signal}
no debug platform led {generic | signal}
Display LED generic action debug messages.
Display LED signal bit map debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Cisco Catalyst Blade Switch 3020 for HP Command Reference
debug platform led
B-35
Advertisement
Table of Contents
