Vlan Database - Cisco Catalyst 3030 Command Reference Manual

vlan database

vlan database
Use the vlan database privileged EXEC command to enter VLAN configuration mode. From this mode,
you can add, delete, and modify VLAN configurations for normal-range VLANs and globally propagate
these changes by using the VLAN Trunking Protocol (VTP). Configuration information is saved in the
VLAN database.
VLAN configuration mode is only valid for VLAN IDs 1 to 1005.
Note
Syntax Description
This command has no arguments or keywords.
Defaults No default is defined.
Command Modes Privileged EXEC
Command History Release
12.2(25)SEE
Usage Guidelines
You can use the VLAN database configuration commands to configure VLANs 1 to 1005. To configure
extended-range VLANs (VLAN IDs 1006 to 4094), use the
enter config-vlan mode. You can also configure VLAN IDs 1 to 1005 by using the vlan global
configuration command.
To return to the privileged EXEC mode from the VLAN configuration mode, enter the exit command.
Note This command mode is different from other modes because it is session-oriented. When you add, delete,
or modify VLAN parameters, the changes are not applied until you exit the session by entering the apply
or exit command. When the changes are applied, the VTP configuration version is incremented. You can
also not apply the changes to the VTP database by entering abort.
When you are in VLAN configuration mode, you can access the VLAN database and make changes by
using these commands:
•
•
Cisco Catalyst Blade Switch 3030 Command Reference
2-546
vlan database
Modification
This command was introduced.
vlan: accesses subcommands to add, delete, or modify values associated with a single VLAN. For
more information, see the
vtp: accesses subcommands to perform VTP administrative functions. For more information, see the
vtp (VLAN configuration)
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
vlan (VLAN configuration)
command.
vlan (global configuration)
command.
command to
78-17262-01