Show Platform Tcam C - Cisco Catalyst 3030 Command Reference Manual

Appendix C Cisco Catalyst Blade Switch 3030 Show Platform Commands
table {acl | all | local |
mac-address | qos | station |
vlan-list}
usage
[[asic number [detail [invalid]] |
[index number [detail [invalid]] |
invalid | num number [detail
[invalid]] | invalid] | [invalid] |
[num number [detail [invalid]] |
invalid]]
| begin
| exclude
| include
expression
Though visible in the command-line help strings, the ipv6, equal-cost-route, multicast-expansion,
Note
secondary, and usage keywords are not supported.
Command Modes
Privileged EXEC
Command History Release
12.2(25)SEE
Usage Guidelines
You should use this command only when you are working directly with your technical support
representative while troubleshooting a problem. Do not use this command unless your technical support
representative asks you to do so.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
78-17262-01
Display lookup and forwarding table information. The keywords
have these meanings:
acl—Display the access-control list (ACL) table.
•
• all—Display all the TCAM tables.
local—Display the local table.
•
mac-address—Display the MAC-address table.
•
qos—Display the QoS table.
•
station—Display the station table.
•
vlan-list—Display the VLAN list table.
•
Display the CAM and forwarding table usage.
Display information. The keywords have these meanings:
asic number—Display information for the specified ASIC
•
device ID. The range is 0 to 15.
detail [invalid]—(Optional) Display valid or invalid details.
•
index number—(Optional) Display information for the
•
specified TCAM table index. The range is 0 to 32768.
num number—(Optional) Display information for the
•
specified TCAM table number. The range is 0 to 32768.
(Optional) Display begins with the line that matches the
expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified
expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Cisco Catalyst Blade Switch 3030 Command Reference
show platform tcam
C-29