Cisco Catalyst 3030 Command Reference Manual page 290

setup
Would you like to enter basic management setup? [yes/no]: yes
Configuring global parameters:
Enter host name [Switch]:host-name
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: enable-secret-password
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: enable-password
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: terminal-password
Configure SNMP Network Management? [no]: yes
Community string [public]:
Current interface summary
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
Vlan1
GigabitEthernet0/1
GigabitEthernet0/2
<output truncated>
Port-channel1
Enter interface name used to connect to the
management network from the above interface summary: vlan1
Configuring interface vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: ip_address
Subnet mask for this interface [255.0.0.0]: subnet_mask
The following configuration command script was created:
hostname host-name
enable secret 5 $1$LiBw$0Xc1wyT.PXPkuhFwqyhVi0
enable password enable-password
line vty 0 15
password terminal-password
snmp-server community public
!
no ip routing
!
interface GigabitEthernet0/1
no ip address
!
interface GigabitEthernet0/2
no ip address
!
Use this configuration? [yes/no]: yes
!
Cisco Catalyst Blade Switch 3030 Command Reference
2-262
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
IP-Address OK? Method Status
172.20.135.202 YES NVRAM
unassigned YES unset
unassigned YES unset
unassigned YES unset
Protocol
up up
up up
up down
up down
78-17262-01