Police - Cisco Catalyst 3030 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands

police

Use the police policy-map class configuration command to define a policer for classified traffic. A
policer defines a maximum permissible rate of transmission, a maximum burst size for transmissions,
and an action to take if either maximum is exceeded. Use the no form of this command to remove an
existing policer.
Syntax Description rate-bps
burst-byte
exceed-action drop
exceed-action
policed-dscp-transmit
Defaults
No policers are defined.
Command Modes Policy-map class configuration
Command History Release
12.2(25)SEE
Usage Guidelines When configuring hierarchical policy maps, you can only use the police policy-map command in a
secondary interface-level policy map.
The port ASIC device, which controls more than one physical port, supports 256 policers (255 policers
plus 1 no policer). The maximum number of policers supported per port is 64. Policers are allocated on
demand by the software and are constrained by the hardware and ASIC boundaries. You cannot reserve
policers per port. There is no guarantee that a port will be assigned to any policer.
To return to policy-map configuration mode, use the exit command. To return to privileged EXEC mode,
use the end command.
78-17262-01
police rate-bps burst-byte [exceed-action {drop | policed-dscp-transmit}]
no police rate-bps burst-byte [exceed-action {drop | policed-dscp-transmit}]
Specify the average traffic rate in bits per second (bps). The range is 1000000
to 1000000000.
Specify the normal burst size in bytes. The range is 8000 to 1000000.
(Optional) When the specified rate is exceeded, specify that the switch drop
the packet.
(Optional) When the specified rate is exceeded, specify that the switch
changes the Differentiated Services Code Point (DSCP) of the packet to that
specified in the policed-DSCP map and then sends the packet.
Modification
This command was introduced.
Cisco Catalyst Blade Switch 3030 Command Reference
police
2-235