Cisco Catalyst 3030 Command Reference Manual page 94

dot1x critical (interface configuration)
You can configure the inaccessible bypass feature and port security on the same switch port.
Examples This example shows how to enable the inaccessible authentication bypass feature on port 1:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# dot1x critical
Switch(config-if)# end
Switch(config)# end
Switch#
You can verify your configuration by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands Command
dot1x critical (global configuration)
show dot1x
Cisco Catalyst Blade Switch 3030 Command Reference
2-66
[interface interface-id]
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
Description
Configures the parameters for the inaccessible authentication
bypass feature on the switch.
Displays IEEE 802.1x status for the specified port.
78-17262-01