Cisco Catalyst 3030 Command Reference Manual page 340

show interfaces
Queueing strategy: fifo
Output queue :0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
This is an example of output from the show interfaces accounting command.
Switch# show interfaces accounting
Vlan1
Interface Vlan2 is disabled
Vlan7
No traffic sent or received on this interface.
Vlan31
No traffic sent or received on this interface.
GigabitEthernet0/1
No traffic sent or received on this interface.
GigabitEthernet0/2
No traffic sent or received on this interface.
<output truncated>
Cisco Catalyst Blade Switch 3030 Command Reference
2-312
2 packets input, 1040 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
4 packets output, 1040 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
Protocol
IP
Spanning Tree
ARP
Protocol
Protocol
Protocol
Protocol
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
Pkts In Chars In Pkts Out
1094395 131900022
283896 17033760
63738 3825680
Pkts In Chars In Pkts Out
Pkts In Chars In Pkts Out
Pkts In Chars In Pkts Out
Pkts In Chars In Pkts Out
Chars Out
559555 84077157
42 2520
231 13860
Chars Out
Chars Out
Chars Out
Chars Out
78-17262-01