Setup - Cisco Catalyst 3030 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands

setup

Use the setup privileged EXEC command to configure the switch with its initial configuration.
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History Release
12.2(25)SEE
Usage Guidelines When you use the setup command, make sure that you have this information:
•
•
When you enter the setup command, an interactive dialog, called the System Configuration Dialog,
appears. It guides you through the configuration process and prompts you for information. The values
shown in brackets next to each prompt are the default values last set by using either the setup command
facility or the configure privileged EXEC command.
Help text is provided for each prompt. To access help text, press the question mark (?) key at a prompt.
To return to the privileged EXEC prompt without making changes and without running through the entire
System Configuration Dialog, press Ctrl-C.
When you complete your changes, the setup program shows you the configuration command script that
was created during the setup session. You can save the configuration in NVRAM or return to the setup
program or the command-line prompt without saving it.
Examples
This is an example of output from the setup command:
Switch# setup
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.
78-17262-01
setup
Modification
This command was introduced.
IP address and network mask
Password strategy for your environment
Cisco Catalyst Blade Switch 3030 Command Reference
setup
2-261