Debug Platform Messaging Application - Cisco Catalyst 3030 Command Reference Manual

debug platform messaging application

debug platform messaging application
Use the debug platform messaging application privileged EXEC command to enable debugging of
application messaging activity. Use the no form of this command to disable debugging.
Syntax Description all
badpak
cleanup
events
memerr
messages
usererr
Though visible in the command-line help strings, the stackchg keyword is not supported.
Note
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(25)SEE
Usage Guidelines The undebug platform messaging application command is the same as the no debug platform
messaging application command.
Related Commands Command
show debugging
Cisco Catalyst Blade Switch 3030 Command Reference
B-38
debug platform messaging application {all | badpak | cleanup | events | memerr | messages |
usererr}
no debug platform messaging application {all | badpak | cleanup | events | memerr | messages
| usererr}
Display all application-messaging debug messages.
Display bad-packet debug messages.
Display clean-up debug messages.
Display event debug messages.
Display memory-error debug messages.
Display application-messaging debug messages.
Display user-error debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Appendix B Cisco Catalyst Blade Switch 3030 Debug Commands
78-17262-01