Show Mls Qos Vlan - Cisco Catalyst 3030 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands

show mls qos vlan

Use the show mls qos vlan user EXEC command to display the policy maps attached to a switch virtual
interface (SVI).
Syntax Description
vlan-id
| begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.2(25)SEE
Usage Guidelines The output from the show mls qos vlan command is meaningful only when VLAN-based quality of
service (QoS) is enabled and when hierarchical policy maps are configured.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show mls qos vlan command:
Switch> show mls qos vlan 10
Vlan10
Attached policy-map for Ingress:pm-test-pm-2
Related Commands Command
policy-map
78-17262-01
show mls qos vlan vlan-id [ | {begin | exclude | include} expression]
Specify the VLAN ID of the SVI to display the policy maps. The range is 1 to
4094.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Description
Creates or modifies a policy map that can be attached to
multiple ports and enters policy-map configuration mode.
Cisco Catalyst Blade Switch 3030 Command Reference
show mls qos vlan
2-375