Ip Igmp Snooping Vlan Static - Cisco Catalyst 3030 Command Reference Manual

ip igmp snooping vlan static

ip igmp snooping vlan static
Use the ip igmp snooping static global configuration command to enable Internet Group Management
Protocol (IGMP) snooping and to statically add a Layer 2 port as a member of a multicast group. Use
the no form of this command to remove ports specified as members of a static multicast group.
Syntax Description vlan-id
ip-address
interface interface-id
Defaults
By default, there are no ports statically configured as members of a multicast group.
Command Modes Global configuration
Command History Release
12.2(25)SEE
Usage Guidelines VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMP
snooping.
The configuration is saved in NVRAM.
Examples This example shows how to statically configure a host on an interface:
Switch(config)# ip igmp snooping vlan 1 static 0100.5e02.0203 interface gigabitethernet0/1
Configuring port gigabitethernet0/1 on group 0100.5e02.0203
You can verify your settings by entering the show ip igmp snooping privileged EXEC command.
Cisco Catalyst Blade Switch 3030 Command Reference
2-138
ip igmp snooping vlan vlan-id static ip-address interface interface-id
no ip igmp snooping vlan vlan-id static ip-address interface interface-id
Enable IGMP snooping on the specified VLAN. The range is 1 to 1001
and 1006 to 4094.
Add a Layer 2 port as a member of a multicast group with the specified group
IP address.
Specify the interface of the member port. The keywords have these
meanings:
gigabitethernet interface number—a Gigabit Ethernet IEEE 802.3z
•
interface.
port-channel interface number—a channel interface. The range is 0
•
to 48.
Modification
This command was introduced.
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
78-17262-01