Debug Platform Etherchannel - Cisco Catalyst 3030 Command Reference Manual

debug platform etherchannel

debug platform etherchannel
Use the debug platform etherchannel privileged EXEC command to enable debugging of
platform-dependent EtherChannel events. Use the no form of this command to disable debugging.
Syntax Description init
link-up
rpc
warnings
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(25)SEE
Usage Guidelines The undebug platform etherchannel command is the same as the no debug platform etherchannel
command.
Related Commands Command
show debugging
Cisco Catalyst Blade Switch 3030 Command Reference
B-30
debug platform etherchannel {init | link-up | rpc | warnings}
no debug platform etherchannel {init | link-up | rpc | warnings}
Display EtherChannel module initialization debug messages.
Display EtherChannel link-up and link-down related debug messages.
Display EtherChannel remote procedure call (RPC) debug messages.
Display EtherChannel warning debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Appendix B Cisco Catalyst Blade Switch 3030 Debug Commands
78-17262-01