Cisco Catalyst 3030 Command Reference Manual page 240

mls qos srr-queue output dscp-map
Usage Guidelines The drop-threshold percentage for threshold 3 is predefined. It is set to the queue-full state.
The egress queue default settings are suitable for most situations. You should change them only when
Note
you have a thorough understanding of the egress queues and if these settings do not meet your QoS
solution.
You can assign two weighted tail-drop (WTD) threshold percentages to an egress queue by using the mls
qos queue-set output qset-id threshold global configuration command.
You can map each DSCP value to a different queue and threshold combination, allowing the frame to
follow different behavior.
You can map up to eight DSCP values per command.
Examples
This example shows how to map a port to queue-set 1. It maps DSCP values 0 to 3 to egress queue 1 and
to threshold ID 1. It configures the drop thresholds for queue 1 to 50 and 70 percent of the allocated
memory, guarantees (reserves) 100 percent of the allocated memory, and configures 200 percent as the
maximum memory that this queue can have before packets are dropped.
Switch(config)# mls qos srr-queue output dscp-map queue 1 threshold 1 0 1 2 3
Switch(config)# mls qos queue-set output 1 threshold 1 50 70 100 200
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# queue-set 1
You can verify your settings by entering the show mls qos maps, the show mls qos interface
[interface-id] buffers, or the show mls qos queue-set privileged EXEC command.
Related Commands Command
mls qos srr-queue output cos-map
mls qos queue-set output threshold
queue-set
show mls qos interface
show mls qos maps
show mls qos queue-set
Cisco Catalyst Blade Switch 3030 Command Reference
2-212
Chapter 2
Description
Maps class of service (CoS) values to an egress queue or maps
CoS values to a queue and to a threshold ID.
Configures the WTD thresholds, guarantees the availability of
buffers, and configures the maximum memory allocation to a
queue-set.
Maps a port to a queue-set.
buffers Displays quality of service (QoS) information.
Displays QoS mapping information.
Displays egress queue settings for the queue-set.
Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
78-17262-01