Match (Access-Map Configuration) - Cisco Catalyst 3030 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands

match (access-map configuration)

Use the match access-map configuration command to set the VLAN map to match packets against one
or more access lists. Use the no form of this command to remove the match parameters.
Syntax Description ip address
mac address
name
number
Defaults The default action is to have no match parameters applied to a VLAN map.
Command Modes Access-map configuration
Command History Release
12.2(25)SEE
Usage Guidelines You enter access-map configuration mode by using the
You must enter one access list name or number; others are optional. You can match packets against one
or more access lists. Matching any of the lists counts as a match of the entry.
In access-map configuration mode, use the match command to define the match conditions for a VLAN
map applied to a VLAN. Use the action command to set the action that occurs when the packet matches
the conditions.
Packets are matched only against access lists of the same protocol type; IP packets are matched against
IP access lists, and all other packets are matched against MAC access lists.
Both IP and MAC addresses can be specified for the same map entry.
78-17262-01
match {ip address {name | number} [name | number] [name | number]...} | {mac address {name}
[name] [name]...}
no match {ip address {name | number} [name | number] [name | number]...} | {mac address
{name} [name] [name]...}
Set the access map to match packets against an IP address access list.
Set the access map to match packets against a MAC address access list.
Name of the access list to match packets against.
Number of the access list to match packets against. This option is not valid for MAC
access lists.
Modification
This command was introduced.
match (access-map configuration)
vlan access-map global configuration command.
Cisco Catalyst Blade Switch 3030 Command Reference
2-173