Show Auto Qos - Cisco Catalyst 3030 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands

show auto qos

Use the show auto qos user EXEC command to display the quality of service (QoS) commands entered
on the interfaces on which automatic QoS (auto-QoS) is enabled.
Syntax Description
interface [interface-id]
Command Modes User EXEC
Command History Release
12.2(25)SEE
Usage Guidelines The show auto qos command output shows only the auto-QoS command entered on each interface. The
show auto qos interface interface-id command output shows the auto-QoS command entered on a
specific interface.
Use the show running-config privileged EXEC command to display the auto-QoS configuration and the
user modifications.
To display information about the QoS configuration that might be affected by auto-QoS, use one of these
commands:
•
•
•
•
•
•
Examples
This is an example of output from the show auto qos command after the auto qos voip cisco-phone and
the auto qos voip cisco-softphone interface configuration commands are entered:
Switch> show auto qos
GigabitEthernet0/4
auto qos voip cisco-softphone
GigabitEthernet0/5
auto qos voip cisco-phone
GigabitEthernet0/6
auto qos voip cisco-phone
78-17262-01
show auto qos [interface [interface-id]]
Modification
This command was introduced.
show mls qos
show mls qos maps cos-dscp
show mls qos interface [interface-id] [buffers | queueing]
show mls qos maps [cos-dscp | cos-input-q | cos-output-q | dscp-cos | dscp-input-q |
dscp-output-q]
show mls qos input-queue
show running-config
(Optional) Display auto-QoS information for the specified port or
for all ports. Valid interfaces include physical ports.
Cisco Catalyst Blade Switch 3030 Command Reference
show auto qos
2-269